crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Gia Barkettcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gia Barkett

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* blue] Locate the 2 solder joints on both sides of the LCD casing.
-[* black] De-solder the joints.
+[* blue] Looking at the LCD casing, you should find two smaller solder joints. There will be one on either side of the camera whoch secure the casing to the circuit board. These are usually shiny and metallic points where the casing connects to the board.
+[* black] Apply the tip of the heated smolder to the first joint to remove it. Contiune with the other side.