crwdns2933805:0crwdne2933805:0
crwdns2933797:0Dancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dan
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] |
|---|---|
| - | [* black] ''Follow these steps if the cell outputs 3.6V |
| + | [title] If the battery is charged to greater than 3.6V... |
| + | [* black] ''Follow these steps if the cell outputs significantly more than 3.6V.'' |
| [* black] In order to get the cell back into a working condition we'll need to cycle it by discharging heavily and then slowly recharging to a point where the RAID card can pick up. | |
| [* black] Find a ~100 ohm resistor or a torch bulb (flashlight for those over the pond) and connect it directly to the cell terminals, ***''ensuring they do not touch.''*** | |
| [* black] Leave the battery for a few hours until you no longer see the bulb lit (or just barely), or if you're using a resistor when the cell voltage drops significantly below 3V. Now disconnect the load. | |
| [* black] ++Never leave the battery unattended while charging / discharging!++ It's not intended to be used in this way, so we need to look after it. |