crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Emilio Martinezcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Use the soldering iron to solder a new wire ending in a copper track on to the circular antenna located next to the main programming chip.
+[* black] Use the soldering iron to desolder the U.FL antenna connector. You might need to use a desoldering braid wire to remove the excess of solder.
[* icon_caution] Soldering iron will be very hot.
-[* black] Let the solder cool for 30-60 seconds.
+[* black] Clean the PCB pads of any excess of solder with the soldering braid wire before continuing.
+[* black] Place the new U.FL connector on the pads where the desoldered connector was. Make sure the orientation of the connector is the same as before.
+[* black] Solder the new U.FL connector to the PCB. Avoid exessive heat and/or prolongated soldering time during this step.