crwdns2933803:01crwdne2933803:0
crwdns2933797:0Benjamin Welkercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Benjamin Welker
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Insert the flat end of the metal spudger into the seam between the screen and back cover of the tablet. |
|---|---|
| - | [* black] Run the spudger along the seam and gently pry at each corner of the device. |
| - | [* icon_caution] Be aware, once front screen is separated, there are ribbon cables still connected and must be removed before further disassembly. |
| + | [* icon_caution] When screen is successfully separated from back panel, there are still two connected ribbon cables between the two components. These cables must be disconnected before further disassembly. |
| + | [* black] Insert the flat tip of the metal spudger into the seam of between the back panel and the screen. |
| + | [* icon_note] It is easiest to get the spudger into the seam at the corners of the device. |
| + | [* black] Slide the spudger across the perimeter of the device and pry gently at each corner. |
| + | [* black] After pressure clamps are released orient device to that the speaker is to the right and tilt the screen away from you. |
| + | [* icon_note] Remember that the ribbon cables are still connected and will be damaged if not handles properly. |