crwdns2933803:06crwdne2933803:0
crwdns2933797:0Jesus Hernandezcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jesus Hernandez
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_note] When the soldering iron is ready, hold the circuit board with one hand and the soldering iron with the other. | |
| [* black] Place the tip of the soldering iron on the first soldered bit that doesn't have a wire connected to it. | |
| [* black] Once the solder begins melting, add a little pressure and you will be able to find a hole through the board. | |
| [* icon_note] Once you can see the hole, remove the soldering iron and perform this on the rest of the lone soldered bits. | |
| - | [* black] Insert your needle through the |
| - | [* icon_caution] Set |
| + | [* black] Insert your needle through the holes you just opened and wiggle it to clear them of any extra solder. |
| + | [* icon_caution] Set the soldering iron down (only on its holder) when not in use. |