crwdns2933803:02crwdne2933803:0
crwdns2933797:0Bryce Nesbittcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bryce Nesbitt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Fit the replacement. | |
| [* black] Examine the end of the rubber wiper: this is what you'll have to match. Unfortunately no guide will help you directly, but many beam wipers seem to use a completely standard rubber pattern. In the example pictured a refill from PIAA worked just fine. | |
| [* black] Cut the new refill to length, if needed. | |
| - | [* black] Use the topmost |
| + | [* black] Use the topmost set of slots in the refill (farthest from the wiping edge). Slide this into the two rails. |
| [* black] Clip the end cap back on to finish the job. Congratulate yourself on a cost efficient and environmentally correct replacement job. |