crwdns2933803:01crwdne2933803:0
crwdns2933797:0Kevin Scottcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kevin Scott
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove all the marked screws using a PH00 screwdriver. | |
| - | [* red] On the bottom, remove the four 3mm screws around the tripod screw hole on the bottom. |
| [* blue] Remove the three 4mm screws on the sides of that bottom that is still remaining. | |
| [* blue] Remove the two 3mm screws on the grip. | |
| [* blue] Remove the two 4mm screws on the side opposite the grip. | |
| [* blue] Separate the two parts of the body of the camera slightly. | |
| [* icon_note] Make sure not to pull too hard because there are connector ribbons. | |
| [* icon_note] Detach the connector ribbons before fully separating the camera into two pieces. This is outlined in the next step. |