crwdns2933803:01crwdne2933803:0
crwdns2933797:0Kevin Scottcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kevin Scott
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove all the marked screws. | |
| - | [* black] |
| - | [* black] On the bottom, four 3mm screws around the tripod screw hole, and three 4mm screws. |
| - | [* black] |
| + | [* black] Remove the two 3mm screws on the grip. |
| + | [* black] On the bottom, remove the four 3mm screws around the tripod screw hole, and the three 4mm screws on the sides if the bottom. |
| + | [* black] Remove the two 4mm screws on the side opposite the grip. |
| [* black] Separate the two parts of the body of the camera slightly. | |
| - | [* icon_ |
| + | [* icon_note] Make sure not to pull too hard because there are connector ribbons. |
| [* black] Detach the connector ribbons before fully separating into two pieces. |