crwdns2933803:02crwdne2933803:0
crwdns2933797:0Brandoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Flip the Roomba back over so you are viewing the top |
|---|---|
| - | [* black] Pull up on the front bumper to remove it |
| - | [* icon_caution] Be careful not to pull |
| - | [* red] Remove the two - 7mm screws with your Phillips head #1, holding the wire sensors in place to the front bumper |
| + | [* black] Flip the Roomba back over, so you are viewing the top. |
| + | [* black] Pull up on the front bumper to remove it. |
| + | [* icon_caution] Be careful not to pull too hard because there is wiring attached to the bumper. |
| + | [* red] Remove the two - 7mm screws with your Phillips head #1, holding the wire sensors in place to the front bumper. |