crwdns2933803:02crwdne2933803:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Flip the Roomba back over, so you are viewing the top. | |
| [* black] Pull up on the front bumper to remove it. | |
| [* icon_caution] Be careful not to pull too hard because there is wiring attached to the bumper. | |
| - | [* red] Remove the two |
| + | [* red] Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper. |