crwdns2933803:05crwdne2933803:0
crwdns2933797:0Winthrop Townsendcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Winthrop Townsend
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Finally locate the two speaker wires connected to the sound and audio motherboard located on the left panel opposite of the speaker. |
|---|---|
| + | [* red] Solder these wires off with a soldering iron. |
| + | [* orange] When wires are disconnected, on order to fully remove the speaker, you may need to cut the plastic bands holding its speaker wires in place. |
| + | [* icon_note] To get to the connections on the motherboard, you will need to peal off the hot glue covering them. |
| + | [* icon_caution] While soldering, the metal connections can get very hot. Never touch the iron with your hand. also make sure that the projector is fully turned off and not plugged in. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0