crwdns2933803:03crwdne2933803:0
crwdns2933797:0Vincent Cookecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Set the heat gun to "Low", and let it run for a few seconds to reach operating temperature. |
|---|---|
| + | [* black] Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature. |
| [* black] Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot. | |
| [* icon_note] This will prevent damage to the board caused by localized thermal expansion. |