crwdns2933803:03crwdne2933803:0
crwdns2933797:0Brett Harttcrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Set the heat gun to "Low", and let it run for a few seconds to reach operating temperature. | |
| [* black] Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot. | |
| [* icon_note] This will prevent damage to the board caused by localized thermal expansion. | |
| - | [* icon_caution] In the next few steps, you will be reflowing the solder under the chips marked in red. |