crwdns2933803:07crwdne2933803:0
crwdns2933797:0Evan Noronhacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Evan Noronha
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Desolder Motors from Flight Controller | |
| [* black] Use a soldering iron and solder wick to desolder the four motors from the control board. | |
| [* black] If the connection holds even after removing the solder from the joint, gently pull up on the wire while applying heat to the joint until the wire separates from the PCB | |
| [* icon_note] The motor wires are in either black-white or red-blue pairs. | |
| - | [* icon_caution] CAUTION: Overheating the PCB can damage the traces, making it difficult or impossible to reconnect the components later on. Do not apply too much heat to the board; these traces are especially delicate due to their size. |
| + | [* icon_caution] CAUTION: Overheating the PCB can damage the traces, making it difficult or impossible to reconnect the components later on. Do not apply too much heat to the board; these traces are especially delicate due to their small size. |
| [* icon_note] VIDEO COMING SOON: It appears my video does not meet the iFixit timing requirements. I will edit it down and upload shortly. |