crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0dancrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] The metal 'spine' you are going to re-shape is under the grey plastic rail with the 'cog teeth' that you can see inside the scanner.
+[* black] 1. Firstly turn over the scanner and remove the three screws on the back of your scanner which are covered by plastic dark grey oval strips. This is so you don't have to turn the scanner over latter when parts can fall out. These screws hold the metal 'spine' in place.