crwdns2933803:04crwdne2933803:0
crwdns2933797:0plink53crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 plink53
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove elevating mechanism |
|---|---|
| + | [* black] The elevating mechanism on the crank side needs to be removed to get to the drive pulley. |
| + | [* black] Remove five M5 x 16MM screws, two on the front and three from the top. Leave center screw along. At this point the assembly can't be removed. |
| + | [* black] Now is a good time to remove the dust collector hood by removing two knobs and lifting the hood out of the way. |
| + | [* black] ***WARNING: Removing the dust collector hood exposes the current cutter blades.*** |
| + | [* black] If planer is mounted to a stand, remove mounting bolts and lay planer on its side. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0