crwdns2894164:0crwdne2894164:0

crwdns2892164:09crwdne2892164:0

crwdns2892146:0Philip Le Richecrwdnd2892146:0crwdne2892146:0

crwdns2875918:0crwdne2875918:0 crwdns2892120:0crwdne2892120:0 Philip Le Riche

crwdns2892174:0crwdne2892174:0
crwdns2892176:0crwdne2892176:0
crwdns2892148:0crwdne2892148:0

crwdns2892168:0crwdne2892168:0

+[* black] With the lens back plate removed, temporarily replace one of the 4 screws which secured it. It will not be possible to drive it fully home; only tighten it until resistance is felt.
+[* black] Lift out the three zoom motor gears and put them aside.
+[* black] Lift the lens off the bench and using a small flat screwdriver, gently turn the gear teeth which the last zoom motor gear engaged with until the lens is open approximately half way.
+[* black] Now feed the two ribbons protruding through a slot in the barrel back into the lens.
+[* black] Resting the lens face-down on the bench, retract it to the closed position by turning the gear teeth in the opposite direction.
+[* black] Remove the screw which had been temporarily reinserted.

crwdns2892134:01crwdne2892134:0

crwdns2892136:0crwdne2892136:0

crwdns2892142:0crwdne2892142:0

crwdns2892134:02crwdne2892134:0

crwdns2892136:0crwdne2892136:0

crwdns2892142:0crwdne2892142:0