crwdns2933803:09crwdne2933803:0
crwdns2933797:0Andrew Optimus Goldheartcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Optimus Goldheart
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_reminder] Important: when you reinstall a logic board, you'll need to replace the thermal paste that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer. |
|---|---|
| - | [* black] Use a firm plastic edge to scrape the thermal material off the heat sink . |
| - | [* black] Apply a new layer of thermal paste to the heat sink |
| + | [* icon_reminder] Important: when you reinstall a logic board, you'll need to replace the thermal paste that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. |
| + | [* black] To properly reassemble your PowerBook, you'll have to clean off and replace the old thermal compound. Use our [guide|744|Applying Thermal Paste Guide] to prepare the processor and heat sink surfaces. |