crwdns2933803:01crwdne2933803:0
crwdns2933797:0guardian10crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 guardian10
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Here it is. The standard 20GB HDD for the Xbox 360. | |
| [* red] Notice the proprietary adapter. Inside is just a pretty standard 2.5" SATA drive... | |
| [* orange] I took these pictures as I was putting it back together, hence the Microsoft warranty sticker looking a little funny. | |
| [* yellow] You may also notice the screw in the bottom left is partly out. This is because as I was replacing the screw before it, I broke my bit. I was using a 1/16" flathead bit (I don't have a T6 Torx) and used just a little too much torque and it snapped. I found another 1/16" bit to finish, but didn't get a pic. | |
| - | [* icon_ |
| + | [* icon_note] If you have Torx bits/drivers, use them. They will work much better than the flatheads. |