crwdns2933803:03crwdne2933803:0
crwdns2933797:0Kris Rodriguezcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kris Rodriguez
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] |
|---|---|
| + | [title] Preparation of Wires and Fittings |
| [* black] Cut a 30 cm long cord (for a table). | |
| [* black] Cut cable 1.3 m long cable (shelves). | |
| [* black] The wire is insulated at both ends. Setting the insulation pliers at the 10 mm mark. | |
| [* black] A quick-connect contact is clamped to one end of the cord. | |
| [* black] The loop contact is pressed onto the other end and a pin with a hammer is hammered onto it. | |
| [* icon_caution] Only the red pliers mark is used to clamp the contact. | |
| [* icon_caution] Check with your fingers that the head clip does not rotate around its axis. If it rotates, the clamp must be replaced with a new one. | |
| [* red] For both wires, one end is terminated with a quick-connect contact, the other end with a pin with a head. |