crwdns2933803:01crwdne2933803:0
crwdns2933797:0Andrew Optimus Goldheartcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Optimus Goldheart
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove the following screws securing the heat sink to the logic board: | |
| [* red] Four 8.6 mm T9 Torx screws | |
| [* orange] One 2.9 mm T6 Torx screw | |
| - | [* icon_note] |
| + | [* icon_note] Be careful not to lose the springs held beneath each of the T9 heat sink screws, they may fall off of the screws as you remove them. |
| [* icon_reminder] During reassembly, tighten these screws evenly to ensure the heat sink stays flat against the CPU. |