crwdns2933803:03crwdne2933803:0
crwdns2933797:0Spencer Jeffersoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Jefferson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing the Filament |
|---|---|
| + | [* red] Set up the printer as you would use it normally by connecting the USB cable from the rear of the printer to your computer and then turning it on. |
| + | [* violet] Once connected to your computer bring up the included up software and click 3D print at the top and select Maintenance. Under the new maintenance window, click withdraw. |
| + | [* black] Wait for the printer to beep to indicate it has fully withdrawn the plastic before you remove the remaining end from the extruder assembly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0