crwdns2933803:01crwdne2933803:0
crwdns2933797:0ihab tahacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 ihab taha
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Remove |
|---|---|
| - | [* red] Lay under the car and locate the crank shaft position sensor. The sensor is located between the engine and the transmission near the front |
| + | [title] Remove Bolt on Crankshaft Position Sensor |
| + | [* red] Lay under the car and locate the crank shaft position sensor. The sensor is located between the engine and the transmission near the front driver's side wheel. |
| [* icon_caution] Make sure the car has not been used in a couple hours. If it has been used recently its parts will still be hot. | |
| [* black] Use the 10mm wrench to loosen the 10mm Hex Head bolt attaching the crankshaft position sensor to the car. | |
| [* icon_note] Note the correct position of the sensor so you will be able to insert the new sensor later on. | |
| [* black] After you have removed the 10mm Hex Head bolt on the sensor pull the sensor out of place with some force. (it should pop right out) |