crwdns2933803:09crwdne2933803:0
crwdns2933797:0Ben Hansoncrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 David Hodson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] De-route the digitizer and LCD cables through the steel inner frame. | |
| + | [* black] If you are replacing a shattered screen, be sure to clean all glass shards from the adhesive areas at the top and bottom of the phone. Failure to do so may result in damaging your new LCD. |
| [* icon_caution] Before re-fastening the front panel to the steel inner frame, be sure both the LCD and digitizer cables are not folded or pinched between the inner frame and the front panel assembly. This will result in possibly damaging the cables and not having enough slack when reconnecting them to the logic board. | |
| [* icon_note] When the front panel has been correctly installed both the LCD and digitizer cables should be immediately next to one another and should be the same length and should be just hanging over the steel frame. | |
| [* icon_note] When replacing the front panel assembly you must remember that you might have to reuse the earpiece grille and the clear plastic ring around the front facing camera from the old/damaged assembly. This will depend on where you buy the replacement part. | |
| [* icon_reminder] After reassembly, protect your new display from any scratches by installing a new [product|IF182-025|screen protector]. |