crwdns2933805:0crwdne2933805:0
crwdns2933797:0william channitacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 william channita
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_note] ***This step is not necessary if you are not replacing the vibration motor.*** | |
| [* black] To remove the wires, you have to first heat up the soldering gun. | |
| [* black] Then, heat up the metal that is connecting the wires to the board. | |
| [* black] Once the metal is heated to a melting point, gently pull on the wire. The wires should then come out with little to no effort. | |
| [* black] The ***red wire*** goes on the left side of the motherboard and the ***blue wire*** goes on the right side of the motherboard. | |
| [* black] To connect the new vibration switch, simply follow these steps in reverse. | |
| + | [* black] ***After all these steps have been completed, you are now done!*** |