crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Walter Galancrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] In the following steps, you will use a heat gun to soften the adhesive securing the underside of the LCD panel to the inner case. The area the adhesive is applied to is shown in red in the second picture.
-[* black] With the heat gun set to low, begin by heating near the upper left corner, then evenly heat the left side of the LCD panel.
+[* black] Use your heat gun to soften the adhesive under the LCD panel along the left edge.