crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Anthony Jungquistcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Anthony Jungquist

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Removing the Motor
-[* black] Place the middle section down that holds the gear system and locate the back of the motor.
-[* icon_caution] Try to clip the wires close to the soldered joints.
+[* black] Place the middle section flat with the side that holds the gear system down and locate the back of the motor.
+[* icon_caution] Clip the wires close to the soldered joints.
[* red] Lift the motor out of the middle section. Using the flush wire cutters, clip the red and the blue wires located on the motor's back.