crwdns2933803:08crwdne2933803:0
crwdns2933797:0Stacey McKennacrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* yellow] To remove the input board (boxed in figure one) first remove the electronic strips (circled in figure one) that connect it to the logic board. |
|---|---|
| - | [* violet] Next, unclip the component from the logic board as shown in image one. |
| + | [* yellow] Remove electronic strips on the right, bottom center, top center, and a cable on the left side of the input board. |
| + | [* black] Remove two screws shown in image ^^74754. Remove the gray connector on top of the input board. |
| + | [* violet] Next, use a flat head screwdriver to assist you in prying the right clip while simultaneously pulling up on the input board. Unclip the component from the logic board. |
| [* icon_note] Note that there is a clip on both the left and right sides of the input board. |