crwdns2933803:09crwdne2933803:0
crwdns2933797:0Markcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mark
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_caution] This step involves removal of the top camera and speaker module. ***Read the next two steps before starting***, as it is easy to rip one ribbon cable if you pry the part too far |
|---|---|
| + | [* red] Insert your spudger as shown. This will involve some pressure, but the right side of the module should begin to lift from the frame |
| + | [* orange] My hand was covering the exact entry point, but you will want to further separate the module from the top left side of the phone (I'm holding it upside down) |
| + | [* yellow] ***Be very careful*** when lifting from the third spot - you only want to separate the clips on the side, ***if you lift the entire piece out of the phone, you can easily rip a ribbon cable underneath the assembly. See the next step for directions on how to fully remove the module*** |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0