crwdns2933803:03crwdne2933803:0
crwdns2933797:0Yajur Duddalacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Loosen screw 1 |
|---|---|
| - | [* black] Do not completely loosen a screw. |
| - | [* black] Loosen each screw a little bit. Going from 1 then to 2 then to 3 and then to 4. Keep doing this until they are all loose. |
| - | [* black] Loosening one completely with out the other screws loosened may damage the logic board |
| - | [* black] Lift the heatsink up, until it won't rise any farther. |
| - | [* black] Pull the heat sink out. |
| + | [* black] Disconnect the blue connector near the top right screw of the heatsink (display cable) by pulling on the blue tab gently. Gently push and/or tape the cable to the chassis away from the heatsink. |
| + | [* black] Slowly unscrew the 4 screws holding the heatsink in, unscrewing each one at the same time, and not one at a time. The recommended screw turning is 1-2 turns per screw. The heatsink will slowly lose pressure and come off, and the screws will make a light click when they are loose. |
| + | [* black] Carefully lift the heatsink from the side with the screws, making sure to pull to the left to free the exhaust side. |