crwdns2894164:0crwdne2894164:0

crwdns2890822:0crwdne2890822:0

crwdns2890844:0crwdne2890844:0

crwdns2861143:0crwdne2861143:0

crwdns2892164:09crwdne2892164:0

crwdns2892146:0Jeff Suovanencrwdnd2892146:0crwdne2892146:0

crwdns2875918:0crwdne2875918:0 crwdns2892120:0crwdne2892120:0 Jeff Suovanen

crwdns2892174:0crwdne2892174:0
crwdns2892176:0crwdne2892176:0
crwdns2892148:0crwdne2892148:0

crwdns2892168:0crwdne2892168:0

[* black] Repeat this procedure with the adjacent battery cell:
[* black] Apply a small amount (about 1 ml) of liquid adhesive remover under the battery cell, and wait 2-3 minutes for it to penetrate and soften the adhesive.
[* black] Apply a small amount (about 1 ml) of liquid adhesive remover under the battery cell, and wait 2-3 minutes for it to penetrate and soften the adhesive.
[* black] Alternatively, re-heat this section with your iOpener if needed.
[* black] Push a plastic card about an inch between the battery cell and the upper case, and slowly pry the cell up to separate all of the adhesive.