crwdns2933803:04crwdne2933803:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
- | [* black] Open your container of adhesive remover. |
---|---|
- | [* black] Fill the syringe included in your kit with a small amount (approximately 1-2 milliliters) of adhesive remover. |
- | [* icon_note] It's best to fill the syringe with no more than about 1-2 milliliters of adhesive remover at a time, so as to avoid accidentally applying too much. |
- | [* black] Refill your syringe as needed throughout the rest of this procedure. |
+ | [* black] Pull off the black rubber stopper from your bottle of adhesive remover. |
+ | [* icon_caution] Twist to loosen or remove the bottle cap before you cut the applicator tip. |
+ | [* icon_note] This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. ***If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.*** |
+ | [* black] Use scissors to cut off the sealed tip of the applicator. |
+ | [* icon_note] Cutting close to the narrow tip will give you better control so you can apply the adhesive remover in small amounts. |
+ | [* icon_caution] Twist and close the bottle cap securely before you proceed further. |
crwdns2933777:01crwdne2933777:0
crwdns2933781:0crwdne2933781:0
crwdns2933783:0crwdne2933783:0
crwdns2933777:02crwdne2933777:0
crwdns2933781:0crwdne2933781:0
crwdns2933783:0crwdne2933783:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0