crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tatianacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tatiana
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] |
|---|---|
| - | [* black] After all are removed, |
| - | [* |
| - | [* black] |
| + | [title] After opening bObsweep, you will see the main board in the center. To take it out, detach all of the circuit plugs. Keep note of where each plug attaches for installation of the new one. |
| + | [* black] After all are removed, uninstall the three screws which secure it to bObsweep. There is one in the centre of the motherboard, near the multicoloured plug for Bob’s left wheel. The second is close to the top right corner. The third is near the bottom right edge. |
| + | [* icon_note] Once all are removed, keep them aside to use later. |
| + | [* black] Lift the main board up and replace it with a new functional one. Make sure the replacement mainboard lies flat overtop of the empty spots where the three screws fit in. Then you will be able to reinstall the screws. |
| [* black] There are two wide, multicoloured circuit plugs that attach to the top edge of the motherboard. One has already been removed in order to detach bObsweep’s cover. The other plugs in on the left side of the open space. | |
| [* black] At the top of the motherboard’s right edge is a wide, red, black, and blue circuit plug. Beneath that is a smaller plug for Bob’s power inlet with orange and black wires. | |
| [* black] The bottom ledge starts with a small circuit plug on the left. It has red, white, and black wires. Then there will be two open spaces between this plug and the next one. It has red,black,white, and brown wires. Then there are three more circuit plugs. A small yellow wired one, another small plug with orange and black wires, and finally a wider multicoloured circuit plug that connects is furthest to the right. | |
| [* black] The order along the motherboard’s left edge from the top down starts with a small yellow and black circuit plug. Below that is where the brush motor’s wires connect. It has two pairs of twisted wires, one red and white, the other pink and black. Just beneath that is another wider, multicoloured circuit plug which is attached to bObsweep’s left wheel. Then there will be one plug left. It is very small and has blue and black twisted wires. | |
| [* black] When everything has been reattached properly, you can start putting Bob’s top back on. |