crwdns2933803:090crwdne2933803:0
crwdns2933797:0robertcbaruchcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 robertcbaruch
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] With calipers, measure the width of each end of the pin. You want to find the smaller of the two ends. The smaller the pin, the more difficult this is. |
|---|---|
| + | [* black] On my machine, the smaller pins had one end ground flush to the part, and the other sticking out. The end that stuck out was the smaller end. |
| + | [* black] Position the part in the arbor press so that the part is supported by the jig you made, and the small end of the pin is up. |
| + | [* black] Press on the pin with the arbor press. If you are close to using all of your strength and the pin has still not moved, give it a few more heat - lubricant cycles. |
| + | [* black] If the thing still doesn't move, you may be pressing on the wrong end. In which case, see the next step. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0