crwdns2933803:01crwdne2933803:0
crwdns2933797:0Jacob Rardincrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jacob Rardin
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Remove the six ribbon cables by releasing the clips (see second photo) and pulling the cables out. |
|---|---|
| + | [* orange] Pry off the gold-plated connector with an opening tool, spudger, tweezers, or a fingernail. |
| + | [* yellow] Desolder the five wires attached to the back of the board. |
| + | [* green] Remove the five silver 4x4mm screws. |
| + | [* black] One is hiding under the wide ribbon cable in the lower-right corner, along with a seventh ribbon cable. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0