crwdns2936039:0How To Use A Multimetercrwdnd2936039:015crwdne2936039:0

crwdns2933803:015crwdne2933803:0

crwdns2933797:0Jeff Suovanencrwdnd2933797:0Mud 22, 2014crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen

	[* black] Place one probe at each end of the circuit or component you want to test.
	[* icon_note] It doesn't matter which probe goes where; resistance is non-directional.
	[* black] If your multimeter reads close to zero, the range is set too high for a good measurement. Turn the dial to a lower setting.
	[* black] If you set the range too low, the multimeter simply reads 1 or OL, indicating that it is overloaded or out of range. This won't hurt the multimeter, but we need to set the dial to a higher range.
-	[* black] The other possibility is that the circuit or component you are testing doesn't have continuity—that is, it has infinite resistance. A non continuous circuit will always read 1 or OL on a ~~continuity~~ test.
+	[* black] The other possibility is that the circuit or component you are testing doesn't have [guide\|25632\|continuity\|stepid=64987]—that is, it has infinite resistance. A non continuous circuit will always read 1 or OL on a resistance test.