crwdns2933803:015crwdne2933803:0
crwdns2933797:0Servausecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Place one probe at each end of the circuit or component you want to measure. | |
| [* icon_note] It doesn't matter which probe goes where; resistance is non-directional. | |
| - | [* black] If your multimeter is |
| + | [* black] If your multimeter is manual ranging: |
| [* black] If your multimeter reads close to zero, the range is set too high for a good measurement. Turn the dial to a lower resistance range. | |
| [* black] If you set the range too low, the multimeter simply reads 1 or OL, indicating that it is overloaded or out of range. This won't hurt the multimeter, but we need to set the dial to a higher range. | |
| [* icon_note] The other possibility is that the circuit or component you are measuring doesn't have [guide|25632|continuity|stepid=64987]—that is, it has infinite resistance. A non continuous circuit will always read 1 or OL on a resistance test. |