crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Whenever you install a screw, first turn the screw counter-clockwise (in the “loosey” direction) to “seat” the screw.
[* black] Turn slowly until you feel the screw level off and sink slightly, then stop.
[* black] Now it's safe to tighten the screw.
-[* icon_note] A properly seated screw will turn easily until it's fully tight.
-[* icon_caution] An improperly seated screw is increasingly difficult to tighten—because its misaligned threads are cutting into the threads in the screw hole, causing permanent damage. This is known as "cross-threading."
- [* black] If your screw doesn't tighten easily, back off and re-seat it.
+[* icon_note] A properly installed screw will turn easily until it's fully tight.
+[* icon_caution] An improperly threaded screw gets increasingly difficult to tighten—because the misaligned threads are cutting across the threads in the screw hole, causing permanent damage. This is known as "cross-threading."
+ [* black] If your screw doesn't tighten easily, back off and carefully re-seat it, and try again.