crwdns2933803:06crwdne2933803:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_note] Smaller press-fit (or "pop") connectors may require a simple flick with a plastic opening tool, spudger, or fingernail. | |
| [* black] Place the flat edge of your tool under the edge of the connector, and pry the connector straight up from its socket. | |
| + | [* icon_caution] Be very careful to pry ***only*** under the flat edge of the connector, and not under the socket itself. If you pry under the socket, you will separate it from the logic board, causing permanent damage. |
| + | [* icon_reminder] To reconnect, align the connector carefully over its socket and press down with your fingertip—first at one side, then the other—until it clicks into place. |
| + | [* icon_caution] ***Do not*** press down on the middle until the connector is fully seated—if it's misaligned, the connector can bend, causing permanent damage. |