crwdns2933805:0crwdne2933805:0
crwdns2933797:0Tyler Turcottecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tyler Turcotte
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Next will be to remove the LCD screen by removing the four indicated screws. After this is accomplished the screen will now be loose. Please note that a ground loop will be attached to one of these screws and will need to be reattached upon reassembly. |
|---|---|
| + | [* black] On the left side of the screen there is a white connector that is attached to the lcd. This need to be removed as well. Pull up on the white connector for removal. (Avoid pulling the wires) |
| + | [* black] On the right side of the board slowly remove the white and black wire out of the channel, at the end of this wire will be to "push connectors." Simply pry these off by hand. Once this is accomplished you can simply set your display aside. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0