crwdns2933803:03crwdne2933803:0
crwdns2933797:0Mehboobcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Geoff Wacker
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] This can be resolved by inserting a screw driver and gently forcing the slot into sight. | |
| [* black] Next a pair of either combination or slip joint pliers are needed to hold the gear, | |
| - | [* black] To remove the blade gear, turn the Magic Bullet on its side and use a flat tip screw driver on the bottom end, and the pliers on the base gear. Turn the blade gear in ***counter clock wise*** direction to remove it of the shaft. |
| + | [* black] To remove the blade gear, turn the Magic Bullet on its side and use a flat tip screw driver on the bottom end, and the pliers on the base gear. Turn the blade gear in ***clock wise*** direction to remove it off the shaft. |
| + | [* green] The blade gear has a left-hand thread, which is opposite to the normal screw thread. So it will loosen when you turn clock-wise. |
| + | [* black] You may find it easier to remove the blade gear after the motor assembly has been removed from the body in Step 8. |
| + | [* black] If the blade gear refuses to budge, give it several sharp taps with a small ball end hammer directed at the center of the boss. |
| + | [* icon_caution] Note that the blade gear needs to be removed only if it is to be changed. |