crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Sam Goldheartcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Goldheart

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Slightly lift the lower end of the logic board and slide it down in the rear case, just enough to clear the clip at the top of the case.
-[* icon_caution] Keep the phone level, as this action will expose a small gold-colored ring that may fall out.
- [* black] Remove the gold-colored ring and set it aside.
+[* black] Holding the phone level, lift the bottom end of the logic board up enough to grasp it with your fingers.
+[* black] Pull the logic board away from the rear-facing camera just enough to expose the gold contact cap under the top end of the board.
+[* black] Remove the gold-colored contact cap from the raised screw hole in the rear case, and set it aside.