crwdns2933803:07crwdne2933803:0
crwdns2933797:0Emmalyncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Emmalyn
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] The side buttons are the red push buttons highlighted in red. |
|---|---|
| - | [* orange] To remove them, flip the board over and desolder the leads highlighted in orange. |
| - | [* black] Replace components with new ones and resolder back in place. |
| + | [* red] ***Next, you will remove the side buttons of the mouse on the bottom of the board.*** |
| + | [* orange] ***Locating the Side Buttons.*** Left on the brown-colored side of the board, there are 2 black-and-white boxes. These are the side buttons (highlighted in red). |
| + | [* yellow] ***Removing the Side Buttons.*** Flip the board over to reveal the green-colored side. To remove the side buttons, desolder the pins of the side buttons (highlighted in orange within the second picture). |
| + | [* green] ***Replacing the Side Buttons.*** Swap out the old side buttons for new buttons. Resolder the pins of the new buttons onto the board. |
| + | [* light_blue] ***Finishing Up***. Once you've securely soldered the new buttons to the board, reassemble your mouse. To do this, repeat Steps 1-6 in reverse. |