crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Emmalyncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Emmalyn

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.
-[* icon_caution] Pull as far up on the wire as possible, but be careful to avoid ripping the wires.
+[* black] Following Step 3, where the bottom and top halves are separated, begin to remove the wires from the white crimp headers. This separates the upper and lower housing units of the mouse.
+[* icon_caution] Pull as far up on the wire as possible. As shown in the photo, this can be done by pulling close to the white crimp header. This technique helps avoid ripping the wires.