crwdns2933803:02crwdne2933803:0
crwdns2933797:0Shannon Graycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Shannon Gray
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Remove the seven screws that are holding in the battery. They can be seen circled in the picture. |
|---|---|
| - | [* black] When unscrewed, lift the battery. There will be a cable connected to the battery. Detach this cable from the board and remove the battery. |
| - | [* black] Attach the replacement battery cable to the board and reassemble. It can be seen highlighted in picture 2. |
| - | [* black] *Note: When reinserting the battery it is easier to put in the long end first and then dropping the other side in. |
| + | [* red] Remove the seven Phillips #1 screws holding the battery in place. |
| + | [* blue] Detach the battery connector by pulling the connector towards the battery. |
| + | [* icon_caution] Pull from the plastic connector, do not pull from the wires. |
| + | [* black] Remove the battery. |
| + | [* icon_note] When reinserting the battery, it is easier to insert from the long end first before lowering the rest of the battery into place. |