crwdns2933803:04crwdne2933803:0
crwdns2933797:0Larsson Johnsoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Larsson Johnson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Using the safe plastic pry tool, pry up the lower plastic covering. |
|---|---|
| - | [* black] Start on the left and move right with the plastic pry tool slowly loosening the adhesive and clips. |
| + | [* icon_caution] Be careful not to pull the plastic housing out right away. The antenna circuit board is still connected to the main body and damage could occur if the antenna is pulled on unnecessarily. |
| + | [* red] Remove the single screw, set next to the vibrate motor, using a philips #000 screw driver. |
| + | [* orange] Use the spudger to pry up the plastic housing holding the vibrate motor and loud speaker. |
| + | [* yellow] Start on the left and slowly move to the right prying up the adhesive and clips holding the plastic unit down. |