crwdns2933803:010crwdne2933803:0
crwdns2933797:0Kari Bachmancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kari Bachman
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] FIRST IMAGE: Using the multi-tool in crimper mode (or a special crimping tool), apply pressure on the connector 'shank' into which you inserted the wire. | |
| [* black] SECOND IMAGE: The ridge that you achieve by crimping should look the same as the connector shown here on the green wire. Give the connector a gentle pull to confirm it is well connected to the wire (it should not slip off). | |
| - | [* black] THIRD IMAGE: Repeat steps |
| + | [* black] THIRD IMAGE: Repeat steps 10 and 11 for the remaining two wires requiring connectors. |