crwdns2933803:04crwdne2933803:0
crwdns2933797:0Andrew Krippnercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Krippner
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Ensure that the front panel is free by pulling back the black cover. If it does not pull back, remove any remaining nuts or screws |
|---|---|
| + | [* black] Locate the three pin connecters between the two PCBS. Gently unplug them by pulling straight up. Use only one hand to ensure safety from electrical shock. This is a rare occurrence but only using one hand will protect you. |
| + | [* black] Remove the PCB from the amp head and set it aside to get ready for soldering |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0