crwdns2933803:03crwdne2933803:0
crwdns2933797:0Jaden Laidigcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jaden Laidig
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] There is one final touch into getting this board out of its shell. There's a little cable ribbon that is attached to the BDP-S1's motherboard. Give it a good tug to pull it out (don't worry, it won't break that easily). |
|---|---|
| + | [* black] And voila! You have successfully taken out the circuit board. Give it a high five. But don't actually, that could hurt the capacitors (and your hand). |
| + | [* orange] And here we see the solder that keeps the RC components strapped into the board. In order to get them off, you'll need a soldering iron, wick, and solder itself. |
| + | [* black] If you don't know how to solder properly, there are plenty of helpful guides online, such as [http://www.instructables.com/id/EHD4UHG1XDEWUSKWVD/?ALLSTEPS|this one]. Make sure to remove the solder all the way before removing the RC jacks, otherwise you could hurt the board. |
| + | [* black] Now you just gotta take off the RC components, place the news ones in, and solder them into the board (again using a soldering guide if you need to). |
| + | [* black] Good work! Now celebrate by listening to your favorite movie! |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0