crwdns2933803:09crwdne2933803:0
crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Replace the two O-rings on the pump plunger using the same method as the previous O-rings. |
|---|---|
| + | [* black] Replace the outlet cap O-ring using the same method as the previous O-rings. |
| + | [* black] Re-assemble the pump by using these instructions in reverse. |
| + | [* icon_note] Remember to not allow the thin bump stop O-rings to get caught in the threads of the pump body. |
| + | [* icon_note] It is a good idea to apply a small amount of Loctite to the outlet cap during re-assembly to prevent the cap from vibrating loose. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0